Chapter 1

Aerodynamics

The four forces on an airplane, how a wing produces lift, and what happens when it can no longer do so. Every later chapter builds on these ideas.

scroll to begin ↓

Topic 1.1

The Four Forces

Four forces act on an airplane in flight, and the way they balance determines how it moves. Lift is produced by the wings and acts perpendicular to the direction the airplane moves through the air. Weight is the pull of gravity toward the earth. Thrust comes from the engine and propeller, pushing the airplane forward, while drag is the resistance of the air, acting against its motion. Every change in the airplane's speed, direction, or altitude is connected to a change in how these forces balance.

Newton's second law explains this relationship: an airplane accelerates whenever the forces acting on it do not balance. Acceleration does not just mean gaining speed; it also includes slowing down or changing direction. When opposing forces are equal, they cancel out, leaving no acceleration in that direction. This is why steady, level flight requires lift to equal weight and thrust to equal drag. The airplane can be moving very quickly while experiencing no acceleration at all, because the forces pushing it in opposite directions are balanced. If lift becomes greater than weight, the airplane accelerates upward. If drag becomes greater than thrust, it slows down.

The pilot changes these forces primarily through the throttle and elevator. The throttle controls engine power, which changes the thrust produced by the propeller. The elevator changes the airplane's pitch, which affects the angle of attack: the angle between the wing's chord line and the oncoming air. Increasing the angle of attack generally produces more lift, but also more drag. If the pilot raises the nose without adding enough power, the increased drag can cause the airplane to slow down. Similarly, reducing power lowers thrust, and the airplane will begin to lose speed or descend unless the pilot adjusts its attitude and flight path. In a steady climb, the airplane must also overcome the component of its weight acting along the upward flight path, which requires more thrust than level flight. In a descent, gravity helps pull the airplane forward along its downward path, allowing it to maintain speed with less thrust.

The arrows in the simulation show the four forces, with thrust and drag enlarged so they stay visible. For each setting, compare lift with weight and thrust with drag. The longer arrow in each pair shows which way the airplane is being pushed. Try 75% throttle, then 50% throttle with +10° pitch, then 0% throttle. In each case, decide which pair is unbalanced and what that should do to speed or height before reading the status line.

Newton's Second Law
\(F_{net} = ma\)
Fnet = net force (the total of the forces in one direction) m = mass of the airplane a = acceleration (change in speed or direction)
Any imbalance produces acceleration in the direction of the net force. In level, steady flight, lift equals weight and thrust equals drag, so a = 0.
50%
0°

Topic 1.2

Airfoil & Pressure Distribution

An airplane wing is designed to push air downward as it moves forward. In response, the air pushes upward on the wing, producing lift. You can see the wing's shape more clearly by looking at its cross-section from the side. This shape is called an airfoil. As air flows around the airfoil, the pressure is not the same everywhere on its surface. Pressure is the force the air exerts on each unit of area. The pressure is generally lower over the upper surface and higher beneath the wing, creating a net force upward.

Bernoulli's equation helps explain the relationship between airspeed and pressure. It tells us that along a streamline, the path followed by a small amount of flowing air, higher airspeed is associated with lower static pressure, while lower airspeed is associated with higher static pressure. Static pressure is the pressure the air exerts on a surface, and it is different from the energy associated with the air's motion. As air flows over the curved upper surface of a wing, it speeds up and its static pressure drops. The pressure beneath the wing is generally higher, so the difference between the two surfaces contributes to the upward force we call lift. This relationship applies to smooth, steady airflow at speeds well below the speed of sound, when friction can be ignored.

Bernoulli's equation describes how pressure and speed are related, but it does not explain the entire reason a wing produces lift. The wing's shape and angle cause it to redirect the airflow downward as the air passes around it. Changing the direction of the moving air requires a force, according to Newton's second law from Topic 1.1. The wing pushes the air downward, and the air pushes the wing upward in return, according to Newton's third law. The pressure difference across the wing and the downward turning of the airflow are two ways of describing the same aerodynamic force, not two separate sources of lift.

A pilot can change how much lift the wing produces by changing its angle of attack: the angle between the wing's chord line, an imaginary line from its front edge to its back edge, and the oncoming air, called the relative wind. Increasing the angle of attack makes the wing redirect the airflow more strongly, increasing the pressure difference and producing more lift. This continues only up to a limit called the critical angle of attack, which is about 15° for the airfoil shown here. Beyond that angle, the airflow separates from the upper surface and lift decreases. This is the beginning of a stall, which the next topic will explain. Airspeed also matters: because the motion-related term in Bernoulli's equation depends on speed squared, doubling the airspeed at the same angle of attack and air density produces roughly four times as much lift. This is why a slower airplane must fly at a higher angle of attack to produce the same lift.

In the simulation, the thin dashed lines are streamlines showing the path of the air, and the color along the wing’s surface shows pressure, with blue marking lower pressure and red marking higher pressure than the surrounding air. The green arrow shows the resulting lift. Raise the angle of attack from 0° to 15° and watch the streamlines crowd together above the wing while the colors and the arrow grow. Then raise the airspeed from 40 to 120 knots at a fixed angle and compare the arrow length.

Bernoulli's Equation
\(P + \frac{1}{2}\rho v^2 = \text{constant}\)
P = static pressure (the pressure the air exerts on a surface) ρ = air density (mass of air per unit volume) v = speed of the air relative to the wing ½ρv² = energy of the air’s motion per unit volume
Along a streamline, where speed goes up, pressure goes down. This is one part of how a wing produces lift
8°
80 kt

Topic 1.3

Stall

A wing produces more lift as its angle of attack increases, but only up to a limit. The angle of attack is the angle between the wing's chord line, an imaginary line from its front edge to its back edge, and the oncoming air. At a certain angle, called the critical angle of attack, the airflow can no longer follow the wing's upper surface smoothly. It separates from the surface, creating a turbulent wake. Lift decreases sharply and drag increases. This is called a stall. A stall does not mean the engine has stopped, and it can happen even at full power. It occurs when the wing exceeds its critical angle of attack, regardless of the airplane's airspeed.

Although angle of attack determines when a wing stalls, airspeed determines how much lift it produces at a given angle. Lift depends on four things: air density, airspeed, wing area, and the lift coefficient. The lift coefficient describes how effectively the wing produces lift at a particular angle of attack. These factors are combined in the lift equation, L = ½ρV²S CL. The coefficient increases as angle of attack increases, until it reaches its maximum value, CLmax, at the critical angle. Once the wing stalls, the coefficient decreases. The equation helps explain why a wing can produce enough lift at a higher airspeed with a smaller angle of attack, but needs a larger angle of attack as the airplane slows down.

Stall speed is the minimum airspeed at which a wing can produce enough lift to maintain level flight. In level flight, lift must equal the airplane's weight. At the stall speed, the wing is already producing as much lift as it can, because it has reached its maximum lift coefficient. The lift equation can therefore be used to calculate the stall speed by setting lift equal to weight and using CLmax. Solving for speed gives the stall speed equation shown below.

The equation shows that stall speed is not one fixed number. A heavier airplane needs more lift to remain level, so it must fly faster to produce that lift before reaching the critical angle of attack. Because weight is under a square root in the equation, a 10% increase in weight raises stall speed by about 5%. Air density matters too: in thinner air, the wing produces less lift at the same airspeed and angle of attack, so stall speed increases. A smaller wing or a lower maximum lift coefficient also raises stall speed.

The same principle applies when an airplane turns. In a level turn, the wings must produce extra lift to support the airplane while also providing the force that turns it. This increases the load on the wings and raises stall speed. At a 60° bank, the wings must produce twice the airplane's weight in lift, which raises stall speed by a factor of √2, or about 41%. An airplane that stalls at 50 knots in level flight would stall at about 71 knots in a level 60° bank. The critical angle of attack has not changed; the wing simply reaches it at a higher airspeed. This is why airspeed alone cannot tell a pilot exactly how close the wing is to stalling. Recognizing and correcting an excessive angle of attack is central to stall recovery, which pilots learn and practice with an instructor.

Stall Speed
\(V_S = \sqrt{\frac{2W}{\rho S C_{L_{max}}}}\)
VS = stall speed in level flight W = airplane weight ρ = air density S = wing area CLmax = maximum lift coefficient (at the critical angle of attack)
A heavier airplane, thinner air, or a smaller wing raises the stall speed.
8°
80 kt

Chapter 1 Complete

You've covered the foundations of aerodynamics.

Ready to see how these forces combine to control an aircraft?